Off fossil fuel, on schedule
Oil and Gas Heat Replacement in Peabody
A heat pump takes over the heating and adds cooling, while the old boiler or furnace gets a written plan of its own. All on dates you can count on.
Retiring the Boiler on a Plan
Oil deliveries. Annual burner cleanings. A boiler that might be on its last season. Owners of older Peabody homes know the list. Replacing that equipment with a heat pump ends most of it at once: one system handles winter heating and summer cooling, and fuel deliveries stop. The switch goes best when it is planned in order. Step one is sizing. Old boilers and furnaces are frequently oversized, so the heat pump's capacity comes from a room-by-room heat-loss figure, not the old nameplate. Step two is the decision about the existing system. If the heat pump will heat the entire house, the old boiler or furnace can be taken out or disconnected, and an oil tank removal can be fitted into the schedule. If you prefer a backup, integrated controls keep the heat pump as the primary source and switch to the old system only in deep cold. Step three is matching that decision to program rules, since incentives often depend on what happens to the old equipment. For Peabody homes that usually means the light plant's program, plus anything a gas account opens up. Step four is the proposal, with price, expected incentive and dates. Then the install, the tests and the paperwork, in that order.
Replacement Checklist
The pieces of a typical switch from fossil fuel to a heat pump.
Existing system survey
Fuel, age, zones and distribution, whether radiators, baseboard or ducts, all recorded.
Right-sized design
Heat pump capacity based on the house, not the old burner.
Decision on the old unit
Removal, disconnection or backup use written down before the proposal is final.
Backup controls
Integrated controls that call on the old system only below a set outdoor temperature.
Tank removal timing
When the oil tank comes out and how that fits the install days.
Domestic hot water
A plan for hot water if the old boiler currently supplies it.
Program alignment
The scope matched to the incentive rules that apply to your accounts.
Replacement Timeline
Describe the current setup
Fuel type, equipment age and any problems so far. We explain the options for the new system and the old one.
Design and decision
After the visit, a proposal arrives with the heat pump layout, the plan for the old equipment, the price, the incentive and the dates.
Switch over
New heat pump in place; the old system pulled, shut off or linked to controls; then tests and paperwork.
Why the Changeover Stays Smooth
The old system has a plan
Boiler, furnace and tank decisions made before the first install day.
Backup wired right
The old equipment only runs when deep cold calls for it.
Dates on paper
Install days and paperwork deadlines written into the proposal.
- Oil, propane or gas
- Boiler and furnace swaps
- Tank plan included
- Integrated backup controls
Ready to Make This the Boiler's Final Season?
Tell us the fuel, the age of the equipment and when you would like to be done. We will map out the switch and the dates.